Back to Rooms

How Do You Fix Scratches in a Wood Floor?

How Do You Fix Scratches in a Wood Floor?
Cleaning Guides Team 31 December 2025

The first question is how deep the scratch goes, because it determines whether this is a five minute job or a floor sanding project. A mark in the finish can usually be dealt with at home. A mark through the finish and into the timber needs filling or refinishing, and on an engineered board there is a limit to how many times that can be done.

How do you tell how deep it is?

Run a fingernail across the scratch. If your nail glides over it, the mark is in the finish only. If it catches, the scratch has gone into the timber.

Look at the colour too. A scratch that shows as a white or grey line is usually in the lacquer. One that shows the pale raw colour of the wood beneath a stained floor has gone through completely.

What works on surface scuffs?

Start with cleaning, because a surprising number of marks are deposits rather than damage. Black scuffs from shoes and furniture often lift with a damp cloth, a clean pencil eraser or a tennis ball rubbed over the mark.

For light scratches in a lacquered finish, a floor specific scratch remover or a wax repair stick matched to the colour will fill and disguise the line. Work it into the scratch, wipe the excess away across the grain, and buff.

What about scratches in an oiled floor?

Oiled floors are far easier to repair, which is one of their main practical advantages. Clean the area, lightly abrade it with a fine pad along the grain, and apply maintenance oil to the patch. It blends into the surrounding floor as it cures, usually invisibly.

A lacquered floor cannot be spot repaired this way, because a new coat of lacquer applied to a patch leaves a visible edge.

How do you deal with a deep scratch or a gouge?

  1. Clean the area and remove any splinters or raised fibres with fine abrasive paper, working along the grain.
  2. Fill with a wood filler or a hard wax stick matched as closely as possible to the floor colour.
  3. Level it off with a plastic scraper rather than a blade.
  4. Allow it to set, then blend with a touch of matching stain if needed.
  5. Seal the repair with a compatible finish if the floor is lacquered.

Colour matching is the difficult part, and it is worth mixing on a spare offcut first if you have one.

Can dents be raised out?

Sometimes. A dent is compressed timber fibre rather than removed material, and steam can swell it back. Place a damp cloth over the dent and apply a hot iron for a few seconds at a time, checking frequently. The fibres absorb moisture and expand.

This works on bare and oiled wood. On a lacquered floor it will damage the finish, so it is only worth trying if you are prepared to refinish the area afterwards.

When is refinishing the right answer?

When the scratches are widespread rather than isolated, when the finish has worn through across a whole traffic lane, or when repairs would be so numerous that the floor would look patched. At that point sanding and recoating produces a uniform result that no amount of spot repair will match.

Solid wood can be sanded several times over its life. Engineered board has a limited wear layer, sometimes only two or three millimetres, and can usually take one or two sandings at most. Check the specification before committing.

What prevents them?

Felt pads under every furniture leg, replaced as soon as they wear or collect grit. No dragging of anything, ever. A doormat at each entrance and ideally a shoes off habit, since grit carried in underfoot is what causes the fine overall scratching that dulls a floor far more than any single gouge. Rugs in the busiest runs. Trimmed claws on dogs, which otherwise leave a distinctive pattern of fine parallel scratches near doors and favourite spots.

More Floors guides · All Rooms guides