Streaky tiled floors are caused by something being left behind rather than something not being removed. In nearly every case it is detergent residue, dirty water dried back onto the surface, or both. Neither responds to more cleaning; both respond to changing the method.
Why does detergent cause streaks?
Because most people use far more than the dose on the bottle, and the excess is not rinsed away. It dries into a thin film that catches the light, attracts dirt, and builds up with each clean so the floor gets progressively duller.
Halving the dose usually improves the result immediately. Many floors clean perfectly well with hot water alone.
What is the two bucket method?
- Fill one bucket with clean water and the correct dose of cleaner.
- Fill a second with plain clean water.
- Dip the mop in the cleaning solution and wring it out well.
- Mop a small section.
- Rinse the mop in the plain water bucket and wring it out.
- Return to the cleaning bucket and continue.
This keeps the cleaning solution clean. With one bucket, every rinse puts the dirt back into the solution, and after a few minutes you are mopping with dirty water.
What is the right order?
Sweep or vacuum thoroughly first, which matters more than the mopping. Grit left on a tiled floor is dragged around by the mop, scratches the surface and turns into a slurry that dries as a film.
Then mop from the far corner towards the door so you are not walking on the wet floor.
How wet should the mop be?
Damp rather than wet. A soaking mop leaves standing water that dries slowly and unevenly, which is itself a cause of streaking, and on a tiled floor it pushes water into the grout.
Wring it out properly. A flat microfibre mop with a spray bottle uses far less water than a string mop and gives a noticeably better finish.
How do you finish?
For the best result, go over the floor a second time with clean water only, then dry it with a clean microfibre cloth or a dry mop head. That final pass removes the residue that causes streaking.
On a small floor it takes two minutes and it is the difference between acceptable and genuinely clean.
What about hard water?
In a hard water area the minerals in the water itself dry as a film. Drying the floor after mopping prevents it. A splash of white vinegar in the rinse water helps on glazed tiles, and must not be used on natural stone or routinely on cement grout.
What causes a cloudy floor that will not clear?
Accumulated residue from months of overdosing, or a previously applied floor polish that has degraded. Strip it with a dilute solution of soda crystals in hot water, applied, left ten minutes and scrubbed, then rinsed twice.
Test in a corner first, and keep soda crystals off natural stone.
Which mop is best?
A flat microfibre mop with washable pads suits most tiled floors. It uses far less water than a string mop, it picks dirt up rather than spreading it around, and the pads go straight into the washing machine afterwards. Keep several pads and change to a fresh one partway through a large floor.
Wash pads without fabric conditioner, which clogs microfibre and destroys its effectiveness.
What is the simplest fix?
Less detergent, cleaner water changed more often, and a dry pass at the end. Those three changes resolve the great majority of streaky floors without buying anything.
What about steam mops?
They avoid the detergent problem entirely, which removes the single most common cause of streaking. They still leave moisture behind that has to evaporate, so a floor cleaned with steam should be left to dry with good ventilation rather than walked on straight away. Avoid them on natural stone and on any floor with loose or damaged grout.